rss

$279.00

Fender Acoustasonic Sfx Pr-370 Acoustic Amp W/ Vocal In


image
Tacoma 1999 JK50CE4 Acoustic Guitar Pre Fender buyout W hardcase
Tacoma 1999 JK50CE4 Acoustic Guitar Pre Fender buyout W hardcase
   US $1,500.00
 117362806115415060 Fender Acoustasonic Sfx Pr 370 Acoustic Amp W/ Vocal In

ebay520 Store

 
 

 
 

 
 

 
 

Fender Acoustasonic SFX PR-370 Acoustic Amp w/ Vocal In

Description

This amp is in great working order. Barely used. Looks very nice. Small 1" or so nick in the tolex on one of the corners.

Sorry. No footswitch for this amp.

Very easy amp to operate and sounds fantastic!

 (SN: M839606)

Note: We also have another one of these in another auction but the front mesh is torn some. It works perfectly and we may even have some replacement mesh for you to replace it so it looks like new.

-------------------------------------------------------------

Tan Tolex type exterior
• Independent channels for acoustic instruments and vocals with individual tone and feedback controls .
• 80 watts per channel @ 8Ù(160 Watts R.M.S. Total).
• 10- and 8-inch Special Design speakers, and a piezo horn for clean, powerful response.
• Exclusive “String Dynamics” control for suppressing high-frequency acoustical instrument harshness.
• Noise reducing phase reverse switches.
• Balanced 1/4 inch TRS (Tip/Ring/Sleeve) and 3-Pin XLR input jacks.
• Insert jacks for connection to external equipment.
Fender’s Stereo Field expansion circuitry processes the signal through one of 32 stereo digital effects.
The stereo signal then enters the SFX matrix circuit which generates up to 300° of stereo imaging!
Traditional Amp Acoustasonic SFX
1. INSTRUMENT - Plug your guitar in here.
2. GAIN - Adjusts the loudness of the instrument channel.
3. TREBLE - Adjusts the high frequency range of the instrument channel.
4. MID - Adjusts the middle frequency range of the instrument channel.
5. BASS - Adjusts the low frequency range of the instrument channel.
6. STRING DYNAMICS - Controls a dynamic tone shaping filter on the instrument channel. Rotating the knob clockwise reduces high-frequency “harshness” when playing at high volumes and maintains “crispness” when playing at lower levels.
7. FEEDBACK NOTCH - SLOWLY rotate this knob to locate and suppress feedback at a specific frequency on the instrument channel.
8. DSP SEND - Adjusts instrument channel send level to the DSP effects circuit.
9. INSERT - Input/output jack* (TRS) for instrument channel connection to effects devices and other line-level equipment.
10. MIC - Plug your microphone in here. This three pin XLR balanced female input connector is intended for input signals from low impedance microphones.
11. LINE/INST - This 1/4 inch TRS input jack is suited for line-level equipment such as high impedance microphones, keyboards and drum machines. It accepts both balanced and unbalanced inputs.
12. GAIN - Adjusts the loudness of the mic/line channel.
13. PHASE - Reverses the phase of the mic/line channel useful for eliminating feedback in instruments using dual pickup configurations.
14. TREBLE - Adjusts the high frequency range of the mic/line channel.
15. MID - Adjusts the middle frequency range of the mic/line channel.
16. BASS - Adjusts the low frequency range of the mic/line channel.
17. FEEDBACK NOTCH - SLOWLY rotate this knob to locate and suppress feedback at a specific frequency on the mic/line channel.
18. DSP SEND - Adjusts mic/line channel send level to the DSP effects circuit.
19. INSERT - Input/output jack*(TRS) for mic/line channel connection to effects devices and other line-level equipment.
20. BYPASS - Switch IN disables the SFX effect.
21. SFX - Adjusts the SFX effect level and intensity.
22. SFX ON - Illuminates when the SFX effect is active.
23. DSP RETURN - Adjusts DSP effect level (wet signal) to be mixed with the “dry” signal. Clockwise rotation increases the DSP wet signal level.
24. MASTER VOLUME - Adjusts overall loudness of the Acoustasonic SFX.
25. OUTPUT PHASE - Reverses the phase of the amplifier, useful for reducing “small environment” feedback.
26. POWER - Illuminates when the Acoustasonic SFX is ON and receiving power.
27. DSP EFFECTS- Select from 32 DSP effects. The DSPsend knob must be turned above “1” for the effect to be heard on either channel. The DSP effects are listed on the next page.
28. CLIP- Flashes when clipping (distortion) is present in the DSP circuit. If unwanted distortion is heard on either channel when this LED flashes, reduce the DSP send level on that channel.
29. SIGNAL- Illuminates when an adequate input signal level exists for proper operation of the the DSP effects circuitry. Increase the DSP send level on each channel in turn so that the signal LED is illuminated when playing at a normal volume for that channel.
* “Insert” jacks utilize the “Y–cord” (stereo-TRS to dual mono-TS) configuration with Tip=send, Ring=return and Sleeve=ground.
Chorus
1 - Slow Sweep
2 - Slow to Medium Sweep
3 - Medium Sweep
4 - Medium to Fast Sweep
5 - Fast Sweep
Flange
1 - Slow Sweep
2 - Slow to Medium Sweep
3 - Medium to Fast Sweep
4 - Fast Sweep
Slap
1 - Quick, Single Echo
Delay
1 - Short
2 - Medium
3 - Long
Reverb/Chorus
1 - Medium Room / Slow Sweep
2 - Medium Room / Medium Sweep
3 - Medium Room / Fast Sweep
4 - Large Hall / Slow Sweep
5 - Large Hall / Medium Sweep
6 - Large Hall / Fast Sweep
Reverb/Delay
1 - Medium Room / Short Delay
2 - Medium Room / Medium Delay
3 - Medium Room / Long Delay
4 - Medium Hall / Short Delay
5 - Medium Hall / Medium Delay
6 - Medium Hall / Long Delay
Room
1 - Small
2 - Large
Hall
1 - Small
2 - Medium
3 - Large
Plate
1 - Small
2 - Large
TYPE: PR 370
PART NUMBER: 022-1301-000 (120V, 60Hz) USA 022-1331-000 (240V, 50Hz) Aust
022-1341-000 (230V, 50Hz) UK 022-1361-000 (230V, 50Hz) Eur
022-1371-000 (100V, 50/60Hz) Jpn
POWER REQUIREMENTS: 450W
POWER AMPLIFIER SECTION
POWER OUTPUT: 80W R.M.S. per channel, (160W R.M.S. Total)
into 8Ù@ <.07% T.H.D., both channels driven
SENSITIVITY: 1.51V (both channels)
PREAMP SECTION
INPUT IMPEDANCE: 10MÙ(Inst), 3.6kÙ(Mic), 36.4kÙ(Line/Inst)
TONE CONTROLS: Treble: +/-15dB @ 15kHz (Inst), +/-15dB @ 15kHz (Mic, Line/Inst)
Mid: +/-12dB @ 1kHz (Inst), +/-12dB @ 1kHz (Mic, Line/Inst)
Bass: +/-12dB @ 100Hz (Inst), +/-12dB @ 100Hz (Mic, Line/Inst)
FEEDBACK NOTCH: -10dB from 80Hz to 700Hz (Inst)
-10dB from 720Hz to 7.2kHz (Mic, Line/Inst)
STRING DYNAMICS: 0 to -15dB @ 6.3kHz (Inst)
PHANTOM VOLTAGE: +15V DC (Mic)
SPEAKER COMPLIMENT: One 8” Fender Special Design speaker (P/N 051016)
One 10” Fender Special Design speaker (P/N 029753)
Single Piezo Horn (P/N 049260)
DIMENSIONS: Height: 29.5 in (73 cm)
Width: 17.5 in (44 cm)
Depth: 13 in (33 cm)
WEIGHT: 62 lb (28.2 kg)

We are liquidating our recording studio. Feel free to check out our other auctions for other great guitars and amps.

Please excuse the picture quality. They were taken at night with minimal light in the studio. All items from the studio are well taken care of and come from a non-smoking environment.

----------------------------------------------

 

Paypal is the only acceptable payment method for this auction.
 Shipping in the continental U.S. only: $109.90
 If you have any questions, please feel free to send a message before bidding and we'll get right back to you as fast as possible. Thanks so much and good luck.

 
 

 
 

 
 

 
 

Visited 1 time

Email This Post Email This Post   

To inquire about availability, pricing, shipping details or any questions about this item, please complete the form below:

Popular Ads Overall

  • No ads viewed yet.